Getting your Nuvio Chiller ready for use is quick and simple! Whether it’s your first setup or you’re reassembling after storage, following these steps will help ensure the chiller is positioned, connected, and ready for an optimal cold plunge experience.
This guide covers everything from unpacking your Chiller to your first cold plunge!
Before you begin, you can also watch this quick setup video for guidance:
Detailed Instructions
1. For faster cooling, fill your tub or Nuvio Pod with minimal water in the coolest spot available. Pro tip: Run the Chiller overnight for an icy plunge first thing in the morning.
2. Place the Chiller next to the tub/pod on a stable surface, leaving a 20-inch gap around it for airflow; avoid covering it.
3. Remove port stoppers, securely twist hoses onto Chiller ports to prevent leaks.
4. Attach the small hose connector to the water pump, then connect it to one of the hoses.
5. Submerge the pump fully BEFORE plugging it into a power source. You can secure it to the tub’s or pod's side if flat.
6. Place the other hose into the tub/pod.
7. Plug in the Chiller, switch on the power and remove the screen protector.
8. Set your temperature using the remote or on-screen display.
9. For Chillers purchased before December 17, 2024:
- On the legacy display, press 'SET' and use the UP/DOWN arrows to set the temperature; hold to adjust faster.
- To switch between °F/°C: Hold 'MODE' & 'SET', press 'MODE', use the UP arrow to change, then press 'MODE' again to confirm.
- For more detailed instructions, click here.
10. For Chillers purchased after December 17, 2024 (shown in the video):
- The on-screen display shows 'Current Temperature, Target Temperature, and Delay Timer'.
- To switch between °F/°C, press '°F/°C' use the UP/DOWN arrows to set the desired temperature.
- To adjust the delay timer, press 'Delay' and use the UP/DOWN arrows.
- For more detailed instructions, click here.
NOTE: ALWAYS unplug or turn off the water pump BEFORE entering the tub. Also, ensure the Chiller is turned off when the pump is off. Running the Chiller without the pump can cause water to freeze inside, leading to malfunctions or leaks.
Need Help?
If you have any questions or something is wrong, don't hesitate to contact our 24/7 support team here!