Need help setting up your Recovery Chiller? Here is a step-by-step guide to a quick and easy setup, in both video & written form.
Instructions
1. Fill your tub or Nuvio Pod with minimal water in the coolest area possible for faster cooling. To keep your chiller water clean, we recommend using our specially formulated All-in-One Water Cleaner.
2. Place the chiller next to the tub on a stable surface, leaving a 20-inch gap around it for airflow; avoid covering it.
3. Remove port stoppers, securely twist hoses onto chiller ports to prevent leaks.
4. Attach the small hose connector to the water pump, then connect it to one of the hoses.
5. Submerge the pump fully BEFORE plugging it into a power source. You can secure it to the tub’s side if flat.
6. Place the other hose into the tub.
7. Plug in the chiller, switch on the power and remove the screen protector.
8. Set your temperature using the remote or on-screen display.
9. For chillers purchased before December 17, 2024:
- On the legacy display, press 'SET' and use the UP/DOWN arrows to set the temperature; hold to adjust faster.
- To switch between °F/°C: Hold 'MODE' & 'SET', press 'MODE', use the UP arrow to change, then press 'MODE' again to confirm.
- For more detailed instructions, click here.
10. For chillers purchased after December 17, 2024:
- The on-screen display shows 'Current Temperature, Target Temperature, and Delay Timer'.
- To switch between °F/°C, press '°F/°C' use the UP/DOWN arrows to set the desired temperature.
- To adjust the delay timer, press 'Delay' and use the UP/DOWN arrows.
- For more detailed instructions, click here.
NOTE: ALWAYS unplug or turn off the water pump BEFORE entering the tub. Also, ensure the chiller is turned off when the pump is off. Running the chiller without the pump can cause water to freeze inside, leading to malfunctions or leaks.